Lizy bordum: Mine is older the stupid thing was under the panel ! I had a rat and all
kinds of money it look like a rat but ball of hair bow it works yeah no
paying anyone i fixed my own fridge too there was actually a mouse in there
..lol saved mega bucks
adisharr: @salmagunda Amen - take this POS back before it's too late.
matthew preston: aw is ur kitty nice? :D
salmagunda: GE washers are junk.. Why don't you have a clip of it going out of balance
and walking acrossed the floor.
brumko2: 1100 RPM
EllysaE: aww kitty cat
Mateo K: what deterget you putted to clean it ? can we put a dish detergent ?
Samantha W: Leave the door cracked on all front load washers so they can breathe a
little bit and dry out. Shutting the door on them when not in use isn't
good. Just opened about an inch is fine :)
adisharr: @brumko2 That sounds like Electolux knows what they are doing. I'd
recommend GE stay out of the washer business because all they seem to
design lately is crap.
brumko2: You know my first washer did the same thing. I had GE out 4 or 5 times for
it not being able to go to the high spin because it could not balance the
load. It also, at times would hit the sides as you said. One guy even told
me that can haapen and was normal. I emailed GE and told them. They
referred me to a consumer affairs dept. They replaced the inner tub saying
it was warped. It still did not work and screeched when spinning. So, after
a call they agreed to replace the unit.
phsal96: kenny the cross-eyed cat! =D
James Kalin: My Frigidaire front loader doesn't have a cleaning cycle. So I use the
bulky cycle which has a higher water level. Instead of bleach, I use a half
a cup of dishwasher detergent. When I'm through washing for the day, I wipe
the door, boot, and detergent drawer and leave the door and drawer open,
and have never had a problem with odor, mold or mildew.
matthew preston: i like kittys :D
brumko2: Yes, that is very true. I wipe the door gasket out and the glass of at the
end of the wash day. You should also keep the lids of top loaders open as
it can smell and the metal lid will eventually rust from the constant
brumko2: After that I have had no problems. But you do have to watch what you loead
together. Pajama lounge pants get twisted easily in things and ball up and
can cause an uneven load. My mom has an electrolux and it has worked
perfect. The fins in the tub are angled and roll the load as it washes and
keep things from getting twisted.
TomZentra: You are supposed to check the washer for pets inside prior to running this
songofmyheart86: i run two clean cycles. one first with two cups of vinegar and then the
next with two cups of bleach.
adisharr: @lithium803 My issues along with many others regarding this series have
NOTHING to do with the shipping bolts. The out of balance sensors are very
poorly designed. The unit should be able to detect when it is on the verge
of self-destruction but cannot. Other times when the load is almost
pefectly balanced, the unit will determine that it is not and stop the
cycle only to try to balance all over again.
lithium803: No need to be uncivil. I'm just saying, I have had no problems with mine,
which leads me to believe that there is something more going on than a
design flaw. If it was a design flaw it would be present in all of the
machines. Not just a few.
lithium803: I have the same set that is in this video, and have had ZERO problems with
them. I think if people would read the instruction manual, remove the
shipping bolts from the rear of the washer and level the washer properly,
the issue would be much less frequent. I love my set, it's nearly silent
and runs like a champ.
James Kalin: The next time I do a cleaning cycle I will try ammonia. I have my water
heater set little high around 150-155 degrees because I have two
dishwashers. I have used ammonia and Pine-Sol (not at the same time) in my
laundry. I have also used Pine-Sol to clean the tub, left if smelling
really nice for a couple weeks.
Carly Mmmhmm: LOL Is the cat in the wash??
GE FRONT LOAD WASHER IN A BASKET CLEAN CYCLE3.9
out of 5