Motorcycle Handlebars - How To Install, Internal Wiring - Video Guide: Tip Of The Week




People Who Liked This Video Also Liked

RAM Motorcycle Handlebar Camera Mount Test & Review
RAM Motorcycle Handlebar Camera Mount Test & Review
HOW TO REMOVE MOTORCYCLE HANDLEBARS
HOW TO REMOVE MOTORCYCLE HANDLEBARS
Motorcycle handlebar grip removal.
Motorcycle handlebar grip removal.
Victory Motorcycles: Adjusting The High-Ball Handlebars For Multiple Riding Positions
Victory Motorcycles: Adjusting The High-Ball Handlebars For Multiple Riding Positions
How to tie down a Motorcycle- Handlebar strap and ratchet tie down review
How to tie down a Motorcycle- Handlebar strap and ratchet tie down review
Renthal Fatbar 1-1/8
Renthal Fatbar 1-1/8" Oversized Handlebars Install Guide - available at Motorcycle-Superstore.com
Motorcycle Handlebars - How to Install. Internal Wiring - Video Guide: Tip of the Week
Motorcycle Handlebars - How to Install. Internal Wiring - Video Guide: Tip of the Week
Choosing the Right Handlebars & Accessories by J&P Cycles
Choosing the Right Handlebars & Accessories by J&P Cycles
Motorcycle Risers - Adjust Your Handle Bars with Ease - Video Guide: Tip of the Week
Motorcycle Risers - Adjust Your Handle Bars with Ease - Video Guide: Tip of the Week
Samsung Galaxy S Motorcycle Handlebar Mount with Dedicated Holder
Samsung Galaxy S Motorcycle Handlebar Mount with Dedicated Holder
Homemade camera mount for bicycle or motorcycle handlebars cheap (virtually free)
Homemade camera mount for bicycle or motorcycle handlebars cheap (virtually free)
BMW Motorcycle Handlebar Risers
BMW Motorcycle Handlebar Risers
RAM motorcycle cell phone mount
RAM motorcycle cell phone mount

Did this video help you?

twinbadger1: Great video ! What size wire loom did you guys use ? Thanks. 

Milo Magno: Shouldn't your take note of what color when to where in the harness and also mark out what color each black wire is spliced to???

SSgtSnuffy: spead your butt.

KompaLuNA: Similar to my Road Star except, 1. I have the 1 piece riser & covers the wire hole on my apes. Would it affect n e thing if i drill a hole in the middle ? 2.stock grips, my guess is, have to buy aftermarket grips, since the one's off of my road star has the screw-on end caps ? Thanks for your help, Very helpful!!

rerun5568: Thank you for fixing the video.

jokersimpala: So watching this video seeing using the same color wire for the extensions and then covered in covering but wasnt soldered to the connector side, so how do you know what wire goes to what for the connector side after its covered, wouldnt it make more sense to remove the pins from the connector and solder to the extensions and then cover and run through the bars then put the pins back in their stock locations

ianusher12: stupid freak, solder does not dry mother freaker.

ianusher12: Hey! will the chick blow me while i do it?

Lowlifebiker666: They should be on Mr Rodgers neighborhood

Eddie Bostero: Kelly you are cute

SSgtSnuffy: 1:18 = boner achieved.

shiengie: correct me if i m wrong, but the clutch lever holder should go in 1st before you do the routing of wires and soldering back the connectors

Milo Magno: *Shouldn't you take note of what color WENT to where in.....
Rating:
Motorcycle Handlebars - How to Install, Internal Wiring - Video Guide: Tip of the Week 4.8 out of 5

Featured Video

How to Insulate Walls


Motorcycle Handlebars - How to Install, Internal Wiring - Video Guide: Tip of the Week