How To Install Replace Heater AC Blower Motor Chevy Silverado Tahoe Sierra 99-02 1AAuto.com




People Who Liked This Video Also Liked

Blower motor replacement GMC Sierra 2003 - 2009 Chevrolet Install Remove Replace How to
Blower motor replacement GMC Sierra 2003 - 2009 Chevrolet Install Remove Replace How to
2003 to 2006 Silverado and Sierra Blower Resistor and Harness Replacement
2003 to 2006 Silverado and Sierra Blower Resistor and Harness Replacement
1998 Chevy 1500 Pickup Heater Problem
1998 Chevy 1500 Pickup Heater Problem
How to Install Replace Blower Motor 1996 GMC Sierra K1500
How to Install Replace Blower Motor 1996 GMC Sierra K1500
DIagnose and Replace GM blower Control Module
DIagnose and Replace GM blower Control Module

Did this video help you?

Dudeareno Rodent: Any info on what amps these motors draw...my blower motor appears to have burnt the power wire and connector terminal..

Threedog1963: I wish my truck was as cleared out as the one you did this job on. I have a center console and extra ducting to deal with.
Ok, I decided to remove just the 3 screws on the bottom duct. Left the one by the gas pedal in because I didn't want to deal with removing center console and ducting. After some serious body contorting on my part, I was able to finally remove motor, working around the bottom duct. I nothing jamming motor up, so I plugged it back in while I held in hand, turned it on, and sure enough, it didn't turn at all on level 1. Level 2,3, and 4, it came on and was grinding. Time to order new motor. Thanks for the video. Will order from you now.

ADVJason: Mines starting to make a screeching noise when the fan comes on then after it warms up some it quiets down. No clue why. It used to be only when very cold. I don't drive it too often but I figured the blower replacement was easy enough to change when it got bad enough. This morning it took a long time to stop the noise. So looks like this is in my future. Thanks for the video it confirmed it should be easy enough to fix.

Davonte Thompson: Thank you so much I fix my air

thomas Huddleston: I used this video for 2004 chevy silverado and it was very helpful. my heater was making a horrible noise when I had it on setting 5 and then it got worse. It ended up being a piece of paper and a chunk of snow stuck in the heater.

Outdoorsmen1214: Hey 1a , I got a 03 Tahoe and water leaks very very bad when is raining and when ac is bad it leaks but it's under carpet so could this be it ?

Jose Garcia: hey 1a auto whats the name of the cover at minute 1:08 do you sell them or know where to get one i need one please help

rod builder: The later Chevys are pretty much the same as this one. You don't have to remove all the cover screws. I think it was the left 2 that we left in place and they're the ones that are hard to get to anyway. The cover will flop down so you can get to the blower and the resistor on the later models as we. Just don't force it and break the plastic!!! I have a 2011.

Rick Bright: Super helpful video. It made this job a snap! It only took me 30 from start to finish thanks you. BTW, I bought the part from you at a fair price and it fit perfect.

DB G: GREAT VIDEOS LIKE ALWAYS!!!!!

Brandon Lee: Hi! What is the plastic part that you pull the fan out of? Mine is all chewed up from a previous owner so I need to replace it. Thanks!

Mark Olsen: I have a 2000 Chevy Silverado 2500 heater works but not the top blower speed, any ideas???

Rudy Montez: AC blower GMC truck

Flaco Sa: my truck dont blow strog air ..do u thik thats the problem

vargasmongo3435: sorry dumb question, will that also the same for a 2001 Yukon too ?

m144mantube: thank you! I just found out that a small rodent of some sort had made a nest in my fan. packed it solid full of grass in one day. oh, and a walnut too. Haha.
Thanks to your video, it turned an hour long job into 30 min.

Randy Nystrom: Hi there, i recently replaced the blower motor resistor on my truck, after losing several speed setting. When hooked it back up and tested the fan I had reduced fan speed and immediately smelled burning. The new resistor was getting hot . Possibly needing a new fan as well?

VolklRunner: Just pulled my old blower to replace with a new one, but was struggling, with removal till I realized there was no shield for the old fan. There are two empty screws holes. Do you think it is OK to run it without a shield, as I have been doing for the last 7 years?My truck is a GMC sierra 2002 2500hd. The blower I removed is a Valeo 52494617 with a manufacture date of 2/23/02. Since the truck is a 2002 could this be the original, just never received a shield???Thanks,Steve

Sean Nicholls: mine blows hot air but not hot enough dos not get hot enough is that the heater core or the blower
Rating:
How To Install Replace Heater AC Blower Motor Chevy Silverado Tahoe Sierra 99-02 1AAuto.com 5 out of 5

Featured Video

How to Insulate Walls


How To Install Replace Heater AC Blower Motor Chevy Silverado Tahoe Sierra 99-02 1AAuto.com