Lee Pro1000 And Load Master 9mm Case Collator Mods




People Who Liked This Video Also Liked

Lee LoadMaster - Case Feeder Setup by HPFirearms
Lee LoadMaster - Case Feeder Setup by HPFirearms
RCBS Bullet feeder on Lee Loadmaster for 45 ACP (HD)
RCBS Bullet feeder on Lee Loadmaster for 45 ACP (HD)
Bullet Feeder Collator Construction - Mechanical. DIY homemade
Bullet Feeder Collator Construction - Mechanical. DIY homemade
Setting Case Retainers on Lee Load-Master
Setting Case Retainers on Lee Load-Master
Low Primer Warning Alarm DIY Lee Loadmaster With IR LED Detector
Low Primer Warning Alarm DIY Lee Loadmaster With IR LED Detector

Did this video help you?

andrew geary: Its crazy people have done this type of mod since 2008 and lee has never fixed there product´╗┐

MyJt7: I think the music was cool and made it interesting, don't listen to these noobs in the comments :) Keep makin cool vids.

stockdue: Ah ah! You right! effectively it sucks! But in that moment sounded good to me ... "shake the body" ..... ah! ah! ;)

stockdue: If you mont the carbide resizing dies there is no need of lube...

bippie23456: Nice tip.... thanks! The music however sucks... I am ever so thankful for a mute button.

takingu2skoo: do you lube your case's?

stockdue: Till now I never reloaded .38special or .357 mag with the pro1000 but only many many thousands of 9x21 but it shouldn't happen with .38spl or 357mag due to their longer case than 9x19 or 9x21....

stockdue: Simply because the holes are a little too big for 9mm cases. So the case flow down also when is faced up. Hole must be closed as much a case faced on will come down only when is bottom faced to the hole of the tube. This because its baricenter is closest to the bottom.

KingstonSwift: "Interesting but I don't understand why it works? How does that little piece of plastic keep the cases from being inserted upside down? " The answer is one end of the case is heaveir than the other so gravity trys to spin the cases around before they go down the holes

stockdue: Cal.9 case baricenter is over the half of the case. Due because the holes are a little big for cal. 9 sometime some cases flush down upside down. This mods work because the pieces of plastic stop the case taking its baricenter behind the edge of the hole. More simple to try than explain. Keep a case between fingers and keep it on the hole. The release it with and w/out the hole restriction.

millca68: Interesting but I don't understand why it works? How does that little piece of plastic keep the cases from being inserted upside down?

Nazzarenom: Bella idea per il 9mm ora lo faccio.Very good!

sifulotdementa: Si pu├▓ fare qualcosa di simile per la RCBS Rock Chucker IV? :-D
Rating:
Lee pro1000 and Load Master 9mm case collator mods 5 out of 5

Featured Video

How to Insulate Walls


Lee pro1000 and Load Master 9mm case collator mods