HOW TO ADJUST & Lubricate Snowblower Chute Control Handle




People Who Liked This Video Also Liked

HOW TO ADJUST & Lubricate Snowblower Chute Control Handle
HOW TO ADJUST & Lubricate Snowblower Chute Control Handle
Ariens Platinum 30 snow blower chute and headlight adjustments / mods.
Ariens Platinum 30 snow blower chute and headlight adjustments / mods.
Ariens 1028 Snowblower  PART 3OF 3:  Chute Tension Adjustment
Ariens 1028 Snowblower PART 3OF 3: Chute Tension Adjustment
How To Grease Lubricate Snowblower Chute Gear Mechanism Toro 824
How To Grease Lubricate Snowblower Chute Gear Mechanism Toro 824
Murray Snowblower Drive Cable Adjustment
Murray Snowblower Drive Cable Adjustment

Did this video help you?

ka1133: Perfect ... just what I needed. Thanks much!!

portagee dosage: Is there any way i can modify my snow blowers discharge cap (up - down) with a cable like the newer snow blowers have.thanks

Matthew Wilson: great video thanks for the tips!

carl mann: Well done video.  I am learning a lot!
Can you explain how to replace the chute tilt guide, bracket and two cables?
I have a 10HP MTD 30 inch.  Similar to what you have in this video.
thanks

Joe Slavin: great video thanks for the tips!

donyboy73: try white lithium grease spray or silicone spray you may also want to lubricate the chute where it tilts

jason mahoney: Hey Dony, I own a Murray Snowblower. Getting ready for the winter. Everything works great on it except the chute up and down cable constantly freezing up on me starting at -25. then at -15 it is ok again. I have sprayed WD40 down the cable before to displace moisture but it is still freezing. Is there a spray that you know off that could eliminate this issue. Thanks for sharing all your videos.

chapel976: @sandmanJB no. it hasn't snowed this year for me to use it yet though.

Jim B: @chapel976 Did you ever get an answer to this? my chute continuously spins

donyboy73: @ERAZ1981 check the gear adjustment at the bottom of the chute and make sure it is well lubricated

ERAZ1981: I have a very old John deere 1032. The chute will rotate fine to a point but then it just stops. I have to wiggle it to get it to turn any farther. It always gets stuck at the same angle. Any ideas?

chapel976: how do you handle a snowblower chute that won't stay? my Ariens ST724 doesn't have those big grooves. so what happens is if I want it to stay in a certain position and the handle is UP, it will eventually fall DOWN and the chute will move

ringbolt9: all your stuff is so good! ive fixed everything just by watching your vids. my snow blower is jumping from 1st gear to reverse.........any ideas what i can check? thanks

donyboy73: you may be able to adjust it from the handle bars

donyboy73: i think that would be covered. i have a craftsman in my shop and i'll look to see if it's the same

donyboy73: I'D LIKE TO TRY THAT STUFF

James Abbe: awesome man.. i just bought one.. and i was looking for this exact answer.. i figured somewhere in youtube would have it ahahah youtube is like endless knowledge of hints...tips..and tricks... thank you so much
Rating:
HOW TO ADJUST & Lubricate Snowblower Chute Control Handle 5 out of 5

Featured Video

How to Insulate Walls


HOW TO ADJUST & Lubricate Snowblower Chute Control Handle